Nexus 3-speed conversion

Well, I’ve finally converted the Kona Africa Bike One into a Three.  Initially I  planned to buy the hub, sprocket, fitting kit, shifter, spokes, rim and rim tape separately and build the wheel from scratch.  However, when I added up the total cost of these components it was coming close to £100.  Before shelling out the cash, I decided I would have a look to see how much the cheapest Nexus/Sturmey /SRAM 3-speed-equipped bike I could find was.  It turned out it was the Raleigh Drift at £187.  Considering that I would have a single speed wheel with coaster brake left over at the end of the process, I decided to buy the whole bike, steal the back wheel, shifter and fittings and replace it with the back wheel from the Kona, with the intention of selling the newly singlespeed Drift on for around the £100 mark.  I get my 3-speed and someone gets a cheap beach cruiser bike.

image[1]

This turned out to be a quite a good idea in the end, after overcoming a few hurdles.  The O.L.D of the Nexus hub was about 10 mm wider than that of my coaster brake hub.  After consulting with Uncle Sheldon I decided to cold set the Kona frame.  With nothing more than an old table leg and some brute force I managed to increase the space between the rear dropouts and the wheel went in without issue.  The 16t sprocket from the Nexus wheel was a bit small for my taste, and it made the third gear essentially redundant.  The gearing of the nexus three-speed hub feels like roughly minus a third in 1st and plus a third in 3rd, so I decided I would swap it for an 18t sprocket like the one which came with the Kona, so that 2nd gear would be the same as my single gear had been previously.  This produced gearing roughly equivalent to a 24-18-12 cassette.  There appeared to be a great deal of confusion online as to whether sprockets from Sturmey, SRAM and Shimano hub gears were all cross-compatible.  Some of the hub gear sprockets I saw appeared to be splined in a similar manner to those used on a cassette:

416293[1] Others appeared to be splined in a different way, with just 3 small protrusions on the inside edge:

After noticing in the forums that the consensus was that the sprockets were interchangeable between most hub gear manufacturers, and also that the second type of sprocket was available from Shimano and Sturmey, I decided to take the plunge and buy one.

I was slightly concerned reading about how fiddly and generally an pain in the arse it had been for many other people to remove and reinstall the snap ring holding the sprocket onto the hub, but my own experience was fairly positive.  I prefer doing this to removing and installing handlebar grips.  All you need is two small flat head screwdrivers to persuade the ring off and on again and that is it.  Much easier than messing with a chain whip and lockring tool.

The only downside is that my rear wheel rim is now pink.  Its not completely negative though, my uncool bike is now that extra bit more uncool, and I assume also less desirable to thieves.

IMAG0019

and finally the bell crank:

IMAG0021 

I am pleased with the result of this conversion, it has greatly improved the effective range of the bike.

Advertisements

2 thoughts on “Nexus 3-speed conversion

  1. Pingback: Five years on a bike (Part One) | Chester Cycling

  2. Pingback: Shimano and hub gears | Chester Cycling

Leave a comment

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s